Steam Function - Krups Pump espresso Manual De Instrucciones

With ground coffee
The type of coffee you choose will determine the strength and taste of your espresso: the
finer your ground coffee, the more intense your espresso will be.
„ Fill the water tank with tepid water and refit it on the appliance, making sure that it is
correctly in place.
„ Plug in your machine.
„ For the best result, we recommend preheating the accessories beforehand (filter holder,
filter and cups) by following the steps above, without adding coffee.
„ Turn on the appliance by pressing the On/Off button.
„ The "On" indicator light will switch on.
„ Add the ground coffee to the 1 cup filter using the measuring spoon (K) (1 spoon = 1
measure = 1 espresso) (22-23) then pack it using the tamper, turning it using a circular
motion (K) (24). Once packed, the coffee measure should not exceed the MAX level (25).
„ For best quality, pack the coffee effectively.
„ Clean off any excess coffee from around the filter holder.
„ Ensure that the selection button is set to the espresso position
(26).
„ Slot the filter holder into place then turn it to the right until it stops (27).
„ The thumb wheel, set to function O, indicates that preheating is in progress. Once
preheating has finished, the espresso indicator light switches on (28).
„ Place a cup under the filter holder and turn the thumb wheel to the left, to the espresso
position, and the coffee will start to flow (29-30).
„ When the cup is filled, turn the thumb wheel to position O to stop the flow (31).
„ Remove the cup(s).
„ Unlock the filter holder by turning it to the left (32) and remove it from the appliance. Do
not touch the filter as it will be hot.
„ To empty out the coffee, invert the filter holder while holding the filter with the flap so that
only the coffee falls away (33).
„ Wash the filter and filter holder under running water to remove the rest of the coffee (34).
„ To make 2 espressos, take the 2 cup filter (F.2) and add 2 measures of ground coffee.
To change the filter in the filter holder, ensure that the filter is positioned with the slot
„
facing the lever of the handle.
„ IMPORTANT / The coffee flow is stopped manually. Do not move away from the machine
when it is in use.
IMPORTANT! If you want to make a coffee after frothing milk, you shoud turn
the thumb wheel to the espresso position
to the espresso position. After few seconds, the coffee indicator will turn off.
Turn the thumb wheel to function O and wait until the coffee indicator lights up.
During this operation, if the coffee and steam indicator lights are switched on at
the same time, repeat the steps above.
4

STEAM FUNCTION

(button not depressed)
and then set the selection button