Program Review; Turning The Controller Off - Nelson SmartZone EZ Serie Guía De Instalación Y Programación

PROGRAM REVIEW

To review the current program, Turn the MODE dial to the PROGRAM position and turn the large
dial to the setting you wish to review (i.e., turn the large dial to TIME to review the time set for the
controller). When you need to view different zones or run times (1, 2, 3), use the SELECT
buttons only.
NOTE: Since you are in the program mode, the potential exists to change the program
accidentally.

TURNING THE CONTROLLER OFF

There are instances when you'll want to suspend watering, either for short periods (while it's
raining if you don't have a sensor connected), or long periods (during winter). To accommodate
this, the SmartZone
suspends all watering operations (including manual/test procedures) from operating. The clock
continues to maintain the current time and date and your program(s) is retained until you want to
run your program(s) again. To run your program, turn the MODE dial back to the AUTO position.
NOTE: The non-volatile memory of the SmartZone
power. If a battery is not present and AC power is lost, the real time for the clock
will be lost. The time will need to be reprogrammed.
EZ can be turned "Off". Turn the MODE dial to the OFF position. This
TM
EZ will maintain your program without
TM
19