Run A Program Manually; Run A 3 Minute Test (Syringe) - Nelson SmartZone EZ Serie Guía De Instalación Y Programación

ADVANCED FEATURES
The SmartZone
procedure. ManualAdvance™ allows you to cease the currently running zone and immediately
advance to any new zone you select. With the MANUAL procedure running a zone, press
SELECT to advance to a new zone. The last entered run time will be displayed. Press
ADJUST to enter a new run time for the new zone (the controller will delay 10 seconds before
starting the new zone).

Run a Program Manually

Turn the large dial to the CYCLE position. The current program letter will flash. To change to a
different program, turn the PROGRAM dial to the desired program (A, B, or C). The controller will
delay 10 seconds before starting the selected program. After running, the controller resets to the
AUTO procedure.
NOTE: CYCLE runs your current program immediately. Changes cannot be made to the
program in the CYCLE procedure.

Run a 3 Minute Test (Syringe)

Turn the large dial to the 3 MINUTE TEST position. A B C will flash on the LCD (they cannot be
changed). This is to let you know the controller will review all three programs and run a 3 minute
test on only those zones that have been programmed. We call this SmartSyringe™.
This feature allows the controller to skip zones that have not been programmed. These may be
zones that are not hooked-up, hence, saving your pump (if equipped).
EZ incorporates Nelson's ManualAdvance™ feature in the MANUAL
TM
21