Charcoal Filter - Haier QVM7167 Manual Del Propietário

OTHER FEATURES
Reset Filter
The red LED indicator will light every 6 months as a reminder
to replace the charcoal filter.
After replacing the charcoal filters, Hold the Rest Filter for 3
seconds to turn off the Red LED indicator.

Charcoal Filter

The charcoal filter cannot be cleaned. It must be replaced.
Order Part No. WB02X11550 from your Haier supplier.
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that helps
remove smoke and odors.
The charcoal filter should be replaced when the red LED
indicator lights under the Reset Filter pad. See "Optional
Kits," page 8, for more information.
To Remove The Charcoal Filter
To remove the charcoal filter, first disconnect power at
the main fuse or circuit breaker, or pull the plug. Open the
microwave oven door and push the "Push" area on charcoal
filter cover at center of the grille. Press back on the top of
the filter with both hands until the filter lays down almost
horizontal. Lift the filter at the bottom until it comes free of
the tabs. Slide the filter down and out.
49-2000650 Rev. 1
Filter
Hold 3 Sec
To Install the Charcoal Filter
To install a new charcoal filter, remove plastic and other
outer wrapping from the new filter.
Insert the top of the filter up and into the grooves on both
sides of the inside of the top opening. Once you have cleared
the bottom tab, push the bottom of the filter in until it rests
in place vertically behind the tab.
Close the charcoal filter cover at center of the grille by
pushing the "Push" area again.
Grooves in
Microwave for
Filter on Each Side
Filter (dashed to show
details of grooves)
Bottom Tab
19