Publicidad
Idiomas disponibles
Idiomas disponibles
2.7.3
Hazardous, flammable materials
Cleaning agent (isopropanol)
Without the corresponding safety precautions, there is a risk of skin irritations, allergic
reactions or respiratory diseases depending on the cleaning agent.
Due to the cleaning agent vapours, there is a risk of fire or explosion if the device and cleaning
agents are handled incorrectly.
When working with cleaning agents, observe the following instructions:
Observe the cleaning agent safety data sheet ("Documents of equal applicability",
page 8).
Store, use and dispose of cleaning products in accordance with the applicable national
regulations and safety data sheets.
Observe applicable fire regulations when handling the cleaning agent.
Wear protective gear ("Personal protective equipment", page 12).
To avoid a fire or explosion hazard, do not spill the cleaning agent.
Observe the requirements for the installation site (see specifications for the position in the
Operating Instructions, "Documents of equal applicability", page 8).
In order to avoid a fire or explosion hazard due to a faulty device or defective safety
features, operate the device only in perfect technical condition, in particular with fitted,
intact seals.
2.8
Safety information for the individual operating phases
2.8.1
Transport
Transport the device only as described in the Operating Instructions (see requirements
regarding transport and setting up in the Operating Instructions, "Documents of equal
applicability", page 8).
In order to avoid corrosion on the device and subsequent damage to the device, transport
and store the device only in the permissible temperature range and ambient conditions
(see requirements regarding the ambient conditions in the Operating Instructions,
"Documents of equal applicability", page 8).
2.8.2
Initial operation
Ensure that this device is only operated by authorized and trained specialists.
If the device has been stored in a cold environment or at high humidity, maintain a drying
or temperature adjustment time of approx. 4 hours (without voltage) at room
temperature before initial operation.
Before connecting the device, check that the supply voltage and frequency are correct at
the point of installation (see electrical data in the Operating Instructions, "Documents of
equal applicability", page 8).
The requirements regarding the location site and ambient conditions must be observed
(see requirements regarding the location site and ambient conditions in the Operating
Instructions, "Documents of equal applicability", page 8).
English
17
Publicidad
