Top View; Front View - Sub-Zero ICB424 Instrucciones De Instalación

M O D E L S I C B 4 2 4 A N D
M O D E L S I C B 4 2 4 A N D
S I T E P R E P A R AT I O N
The Sub-Zero Model ICB424FS wine storage
unit is designed to be attractive in a stand
alone setting. It can also be slid into surround-
ing cabinetry with clearance dimensions
slightly different than the standard built-in
Model ICB424.
Make sure that the finished rough opening
where the Wine Storage unit is to be installed
is properly prepared. Refer to the Installation
Specifications illustration for rough opening
dimensions, door swing clearance and electri-
cal placement for Models ICB424 and
ICB424FS.
IMPORTANT NOTE: To operate properly,
the door must open a minimum of 90 degrees.
Use a minimum 76 mm filler in corner installa-
tions to assure a 90-degree door opening.
Allow enough clearance in front of the unit
for full door swing.
IMPORTANT NOTE: Make sure the floor under
the unit is level with the surrounding finished
floor.
Do not load wine into the Wine Storage
unit until the installation is complete.
I C B 4 2 4 F S I N S TA L L AT I O N
I C B 4 2 4 F S
I N S TA L L AT I O N S P E C I F I C AT I O N S
NOTE: Door swing clearances are based on stainless
steel door and handle dimensions.

TOP VIEW

610 mm
ROUGH
OPENING
DEPTH
ROUGH OPENING
WIDTH
610 mm
MODEL ICB424
619 mm
MODEL ICB424FS
MODEL ICB424
ANTI-TIP BRACKET
LOCATE ELECTRICAL
WITHIN SHADED AREA
394 mm
E
64 mm

FRONT VIEW

90˚
644 mm
660 mm
DOOR CLEARANCE
876 mm
ROUGH
OPENING
HEIGHT
870 mm
MINIMUM
114
HEIGHT
mm
REQUIRED
MODEL ICB424FS
ANTI-TIP BRACKET
606 mm
145˚
MAXIMUM
DOOR SWING
645 mm
1118 mm
DOOR CLEARANCE
M O D E L S
I C B 4 2 4
I C B 4 2 4 F S
3