OPERATION
Hood Controls
The lights and blower are operated using the (5) push buttons located
hood. Fig. 1. It can also be controlled with an optional ACR Series remote control.
Ten Minute Delay
Press Speed 1, Speed 2, or Speed 3 for two (2) seconds when the blower is running at the
selected speed. The LED below the button will start blinking to display the delay function. After
ten (10) minutes, the blower will automatically turn off. If you change the speed while the timer
is running, the function will not deactivate. To deactivate the function, press the button with the
blinking LED for two (2) seconds. Note: The delay is not available for Speed 4.
Filter Alarm
After 30 hours of blower operation, the filter alarm is activated and all of the LED indicators
will turn on. The alarm is activated when the motor is off and the LED's will remain on for 30
minutes. To deactivate the alarm, press any of the control buttons for two (2) seconds while
the LED's are on.
After 120 hours of blower operation, the charcoal filter alarm is activated and all of the LED
indicators will blink. The alarm is activated when the motor is off and the LED's will remain
on for 30 minutes. To deactivate the alarm, press any of the control buttons for two seconds
while the LED's are on.
On / Off
Lights
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When
this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the
blower, do it from the main electrical panel.
Blower
Blower
Speed 1
Speed 2
- 4 -
on the underside of the
Blower
Blower
Speed 3
Speed 4
FIG. 1