MGF S-GH017 Manual De Instrucciones De Funcionamiento Y Mantenimiento página 6

10. Be sure that machine is placed in a well ventilated position to ensure the perfect
cooling of the compressor.
11. Avoid touching metal parts that get hot during operation. Wait for the compressor to
cool down.
12. For safe operation, adjust the pressure regulator to the recommended setting as
indicated by the specific tool or accessory being used for a particular usage and
application.
13. Some paints and other materials are combustible when sprayed and these should
not be sprayed near any flames, heat source or areas where sparks or other sources
of ignition may occur.
14. Make sure that the area is well ventilated when using materials that give off fumes
and when spray painting.
15. Always handle the paint/material to be sprayed in accordance with the
manufacturer's instructions and safety advice.
16. Always wear appropriate protective gear such as safety goggles, mask and gloves,
etc., when spray painting.
17. Always take special care with the electrical cables and hoses, making sure that they
are not put under strain, wrapped, bent or angled or in the way during usage of the
compressor.
18. Make sure that the air supply is switched off and that all pressurized air is expelled
from the compressor and any equipment attached to it when disconnecting or
attaching hoses and/or any other equipment.
19. Any equipment or accessories used in conjunction with the compressor must have a
safety working pressure exceeding that of the compressor.
20. Make sure that any person using the compressor has read and fully understood the
information contained in this Instruction Manual.
MGF Silent compressors operating
instruction manual
6