Abicor Binzel TSi Instructivo De Servicio página 36

11 Disassembly
Fault
Release agent
collects in the
collection
receptacle
Further questions about this device
Tab. 8 Troubleshooting
11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly, disassembly and repair
work:
• Close the compressed air supply.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-13.
1 Remove compressed air lines.
 Fig. 6 Connect the compressed air line on page EN-10
2 Disassemble TSi injection unit.
 Fig. 5 Mounting the device fastener on page EN-9
3 Remove the parts to be disconnected.
EN - 18
Cause
• Collection receptacle/return flow
clogged
Troubleshooting
• Increase cleaning intervals to twice a week
Contact the technical support of
Alexander Binzel Schweisstechnik GmbH & Co. KG:
www.binzel-abicor.com.
BAL.0468.0 • 2019-11-04
TSi injection unit