salmson Module IR Instrucciones De Instalación Y Funcionamiento página 27

ENGLISH
6.3.3 Function menu 3: Operate (continued)
→
1
2
• Function menu 3:
1
Operate
• Click on "Control"
• Click on the required
2
control mode. The
choice of control mode
depends on the
application of the pump
and the type of
installation.
• When clicking on "Plant
setup", the entire work
setting is called up.
→
1
2
• Click on "Auto Night"
1
• Automatic "Autopilot"
2
setback operation is
blocked or approved.
→
3
4
• Click on "Pump On/Off)"
3
• Pump is switched on or
4
off manually.
→
3
4
• Activation of an analog
3
control input 0-10V
• Enable: = control input
4
0-10V activated
• Disable = control input
0-10V deactivated
• Precondition for display
of 0-10V
• corresponding IF module
plugged in
• Pump connected to
interface converter
→
5
6
• Click on "Module"
5
• Pump can be switched
6
from operation at a PLR,
LON, CAN interface to
temporary manual
mode. This allows a local
check to be made.
• PLR: without further
interaction,
the PLR communication
is built up again
automatically after 5
minutes.
• LON, CAN: The module
has to be reset manually
to GLT communication.
→
6
• Block operation at the
5
pump (key function)
• Yes = operation at pump
6
blocked.
• No = operation at pump
approved.
27
5