Elite ARION DIGITAL SMART B+ Manual Del Usuario página 14

EN
be positioned in the hole of the
frame whose measurement given on the graduated
scale is closest to dimension "X" (Fig. 4).
ATTENTION: dimension "Y" must be equal to or
slightly greater than "X". The rollers can be adjusted
to adapt them to bicycles whose wheelbase is 944-
1124 mm (37 to 44 inches).
3) To change Y it is necessary to shift the front roller F).
4) Fold the
Arion Digital Smart B+
slackens.
5) Loosen the drive belt E), making it come off the
respective front and rear guides.
6) Unfold the
Arion Digital Smart B+
position.
7) Remove the rectangular covers C) from both front
longitudinal members (with aid of a screwdriver if
necessary), and the screws and washers from the front
roller on both sides, using the Allen key supplied (Fig.
5 and Fig. 6).
8) Pull the roller out from its original position.
9) Position the roller in the appropriate seat in the
holes in the frame, so that X matches Y.
10) Refit the screws and the washers in the special
holes, but do not tighten them down.
11) Close the Arion Digital Smart
belt E) on the guide of the front roller F) and middle
roller G).
12) Unfold the
Arion Digital Smart B+
position again.
13) Check the position of the front roller F), putting
your bicycle on the rollers and checking that the axle
for the front wheel sits directly above the front roller.
14) Once the front roller F) has been positioned, tighten
the screws without applying too much pressure which
could twist the A) side Frames.
15) Close the sides with the rectangular covers C). The
Arion Digital Smart B+
10
Arion Digital Smart B+
until the drive belt E)
back into the open
B+, position the drive
into open
is now ready to use.
NOTES
• Attention: integrated wireless systems that work
on the same frequency band can interfere with the
data transmission of the Arion Digital Smart B+. In
this case, deactivate them.
• Do not leave the roller and console exposed to
direct sunlight or in particularly humid places for
prolonged periods when not being used.
• Never use chemical detergents (petrol or thinners)
on any part of the Arion Digital Smart B+.
USE
• Plug the power adapter I) into a wall outlet and the
connector into the resistance unit (Fig. 7 and Fig. 8).
• Start pedalling.
TROUBLESHOOTING
• The cadence value is not accurate:
the algorithm that calculates cadence without a sensor
can sometimes vary in accuracy. This might happen
when training with a high pedaling cadence at a low
resistance level.
• If the hometrainer does not connect to the app:
The hometrainer needs to be properly powered up to
work and it needs to connect to a device within 15
minutes, otherwise it will automatically enter its energy
saving phase. Start pedaling or unplug it and plug it in
again to reactivate it, and then connect to a device
within 15 minutes.
ADVICE ON USING YOUR ARION
DIGITAL SMART B+
1) The rollers work best with tyre that has a smooth tread.
If using a mountain bike, to reduce noise and increase
stability change the tyre for one with a slick tread.
2) For beginners, position the rollers in an entrance hall,