Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION SHEET FOR FEDERAL SIGNAL LITESTAK™
Failure to follow all safety precautions and instructions may result in property damage,
Bulbs can burst causing serious injury to the eyes. Always wear safety glasses when changing the
lamp or servicing the unit. Do not apply power to the device without lenses in place.
It is important to follow all instructions shipped with this product. This device is to be installed by
a trained electrician who is thoroughly familiar with the National Electrical Code or the Canadian
Electrical Code and will follow the NEC or CEC Guidelines as well as local codes.
This device may be considered a part of the signaling system and not the entire signaling system.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer. In addition, listed below are some oth-
er important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this light to the system when power is on.
• After installation, ensure that all screws and threaded joints are properly tightened.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the light installation for integrity and proper operation.
I. INSTALLATION.
A. Unpacking.
After unpacking the equipment, examine it for damage that may have occurred in transit. If the
equipment has been damaged, do not attempt to install or operate it. File a claim immediately
with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels
and tags before removing or destroying them.
B. Mounting.
1a. Pipe Mounting.
The Model LSB base is designed for installation on 3/4" NPT pipe.
It may be installed on machines, control boards, or any installation
where pipe mounting is required. If 1/2" pipe is used, a user-sup-
plied reducer is required.
Mounting hardware and installation details are left to the installer.
After the base is installed, the light modules are assembled on the
base. At least one, and up to five light modules may be assembled on the base in any se-
quence (determined by the user). Refer to the instruction sheet for information on how to
assemble the Sound module (Models LSS-024 and LSS-120).
MODELS LSB, LSBS, LSL, AND LSLD.
SAFETY NOTICES
serious injury, or death to you or others.
SAFETY MESSAGE TO INSTALLERS, USERS, AND
MAINTENANCE PERSONNEL
WARNING
DANGER
-1-
290A3796
Publicidad
