Publicidad
Idiomas disponibles
Idiomas disponibles
0.225A, 120VAC, 50/60 Hz
1 sound module (LSS) 0.18A, 24VDC
0.07A, 120VAC
1 lamp module (LSLD) 0.080A, 24VAC/DC
0.045A, 120VAC, 50/60Hz
D. Electrical Connections.
The Light and Sound modules are plug-in units completely wired at the factory and do not
require any wiring. The individual light modules are controlled by the white wire in the base
(Model LSB) with a stripe the same color as the controlled Light module's lens. The Sound
module is controlled by the white/black wire in the base. See table 1. Since the white/black
wire also provides control to the Clear Light module, a Clear Light module cannot be installed
in a LITESTAK™ which contains a Sound module. The control wire for the Sound module and
each Light module must be connected to a control device. See figure 1. Control switch rating
must be capable of handling the power requirements shown in paragraph I.C. above. When
installing the LSB-120 the control wire(s) may be connected for any combination of steady
burning or flashing lights.
To avoid electrical shock hazards, do not connect wires when power is applied.
The base is supplied with 24" wires (18 GA) for connection to the power source and switches.
Use figure 1 and table 1 as a guide and complete the wiring as required. Terminate all unused
wires with user-supplied wire nuts.
Damage to the voltage reducer or wiring may occur if the base top is lifted more than
If desired, the LSB base may be used as a junction box. Remove and retain the four screws
which secure the base top to the base. Lift the base top approximately four-inches. Route the
necessary wires into the base, and use figure 1 and table 1 as a guide to complete the wiring.
Terminate all unused wires with user-supplied wire nuts. After the wiring is completed, replace
the base top and secure with the previously removed screws.
E. Light module Installation.
After the wiring is completed, the light modules are assembled to the base in the sequence
determined by the user. To install the light modules, proceed as follows:
1. Get the first Light module and observe the orientation of the two 3-pin connectors. Also, ob-
serve the orientation of the mating connectors in the base top. Position the Light module on
top of the base with the male and female connectors properly oriented. Align the connectors,
and press the Light module until it snaps into place.
2. See figure 2. There are four holes near the edges of the Light module's clear bottom plate
which align with holes in the base top. To lock the units together, install a snap rivet (sup-
plied with lens) in each hole. Press the head of each rivet until it snaps in place.
3. Assemble all remaining light modules (if any) on top of the first Light module as described
in steps 1 and 2 above.
The snap rivets may be pried out with a flat blade screwdriver.
4. Remove and retain the four plastic pins on the cap (supplied with the base). Install the cap
on the top Light module by aligning the two split pins on the cap with the snap rivet holes
in the Light module's top plate. Press down on the cap until it snaps in place. See figure 2.
Lock the cap in place by pressing a previously removed plastic pin in the center of each of
the cap's split pins.
WARNING
CAUTION
approximately four-inches from the base.
NOTE
-3-
Publicidad
