Publicidad
Idiomas disponibles
Idiomas disponibles
Ensure the proper color lenses are installed on each Light module. A label with the Light module's
5. Position a lens half on the widely spaced pins. Push the lens over the slanted pins until the
lens snaps in place. Repeat with the other lens half.
6. Test the LITESTAK™ to ensure that it operates as intended.
F. Sound module Installation.
Refer to the instruction sheet for the Sound module (Models LSS-024 and LSS-120) for instal-
lation information. The sound module must be the top module on the LITESTAK™.
II. RELAMPING.
Bulbs can burst causing serious injury to the eyes. Always wear safety glasses when changing the
lamp or servicing the unit. Do not apply power to the device without lenses in place.
To change the lamps, proceed as follows:
A. Turn the power off.
B. Insert the blade of a flat blade screwdriver into the slot where the lens halves meet. Pry
toward the light module's center until the lens is released from the pins, and remove the lens.
C. Push the lamp in and turn it counterclockwise. Remove the lamp from the socket.
D. See replacement parts table in section III for complete list of Federal lamps available.
E. Replace the lens.
III. SERVICE.
Federal Signal will service your equipment or provide technical assistance with any problems
that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by a
Return Material Authorization (R.M.A.). This R.M.A. can be obtained from the local distributor
or manufacturer's representative.
At this time a brief explanation of the service requested, or the nature of the malfunction, should
be provided.
IV. REPLACEMENT PARTS (LSLD LED LAMP).
LITESTAK Lens Kit*
Flasher, 24VDC
Flasher, 120VDC
LED Lamp, 24VDC, Amber
LED Lamp, 24VDC, Blue
LED Lamp, 24VDC, Clear
LED Lamp, 24VDC, Green
LED Lamp, 24VDC, Red
LED Lamp, 120VAC, Amber
LED Lamp, 120VAC, Blue
LED Lamp, 120VAC, Clear
LED Lamp, 120VAC, Green
LED Lamp, 120VAC, Red
* Includes one each of lens: amber, blue, clear, green, and red. Does not include Blackout
1/2 lens, snap rivets and cap
NOTE
model number is on it's clear bottom plate.
DANGER
K844700352
K8285237
K8285239
K8107199
K8107199-03
K8107199-04
K8107199-02
K8107199-01
K8107200
K8107200-03
K8107200-04
K8107200-02
K8107200-01
-4-
Publicidad
