Preparing The Humidifier - brondell REVIVE PR50-W El Manual Del Propietario

PREPARING THE HUMIDIFIER

If you do not want to use the Humidifier function, do not perform the steps below. Instead,
remove the Humidifier Filter and store it in a cool, dry location.
If the Water Tank or Water Tray are not properly seated, the Revive will not power on.
1. Remove the Water Tank by pulling the handle up. Then
move the tank away from the machine.
2. Lift the Water Tray slightly and slide it out of the machine.
3. Remove the Humidifier Filter from the Water Tray, remove
the plastic wrapping from the filter, and place back into
the Water Tray.
4. Slide the Water Tray back into the machine, ensuring that
it is seated correctly.
5. Fill the Water Tank:
a. Flip the tank over to access the Water Tank Cap.
b. Remove the Water Tank Cap by turning it counter-
clockwise.
c. Fill the Tank with cold water to the specified fill line.
d. Screw the Water Tank Cap back onto the Tank by
turning it clockwise until tight.
6. Put the Water Tank back onto the machine, ensuring that
it is seated correctly.
If the Water Tank is not properly tightened and seated,
leaking and product malfunction may occur.
Do not fill the Water Tank with water over 104°F.
Do not add disinfectants, essential oils, fragrances, or
any other additives to the water in the Water Tank.
NOTE: The amount of moisture supplied by the Humidifier
Filter may decrease when there is scale build-up.
Check the Humidifier Filter periodically and clean
it when necessary (refer to Step 3 on page 26 for
instructions).
Step 1
Step 2
Step 5
Step 6
15