Humidifier Maintenance; Cleaning The Humidifier Components - brondell REVIVE PR50-W El Manual Del Propietario

HUMIDIFIER MAINTENANCE

CLEANING THE HUMIDIFIER COMPONENTS

Below is a recommended cleaning schedule for the Revive's Humidifier Components. The
frequency is designed to avoid the build-up of scale, mold and/or mildew in the Water Tank, the
Water Tray, and the Humidifier Filter. The frequency of scale build-up depends on the hardness
of the water put into the system. For maximum effectiveness, use a Brondell H2O+ Water
Filtration unit in combination with the Revive.
LOCATION
Right Side
Right Side
Right Side
(Water Tray)
Always unplug the power cord before cleaning the Humidifier Components.
Do not use bleach, chlorine, abrasives, or soaps/detergents that contain solvents.
1. Cleaning the Water Tank
a. Remove the Water Tank by pulling the handle up. Then
move the tank away from the machine. Remove the
Water Tank Cap by turning it counter-clockwise.
b. Fill the Water Tank one-third of the way and add a small
amount of neutral detergent. Replace the Water Tank
Cap and shake the Water Tank vigorously to wash the
inside of the tank. Do not use abrasives.
c. Remove the Water Tank Cap and rinse the inside of
the Water Tank thoroughly, ensuring that there is no
leftover soap inside. While rinsing out the inside, wash
down the exterior of the tank. Do not use abrasives.
d. Dry off the exterior of the Water Tank completely. Fill
the Water Tank with cold water and replace the Water
Tank Cap. Reinstall the Water Tank, ensuring that it is
seated correctly.
NOTE: If you do not want the Revive to humidify the air,
do not fill the Water Tank before you re-install it.
FILTER /PART
Water Tank
Water Tray
Humidifier Filter
METHOD CLEANING CYCLE
Clean Every 2 weeks
Clean Every 2 weeks
Clean Every 2 weeks
Replace Every 4 months
Step 1a
Step 1b
25