brondell REVIVE PR50-W El Manual Del Propietario página 32

TROUBLESHOOTING (cont.)
CONDITION
Airflow has
diminished, even
at high fan speeds.
CONDITION
The Revive runs
only in Fan Speed
3 or 4 while
humidifying is
active.
CONDITION
There is an odor
eminating from
the Revive.
CONDITION
The Air Quality
Indicator is blinking.
30
POSSIBLE CAUSE
Plastic packaging on filters was not
removed.
Blockage at Air Inlet or Air Outlet.
Filters are due for replacement.
Clearance around air purifier is not
adequate for air ventilation.
Missing filters or filters were inserted
in the wrong order.
Recommended room size has been
exceeded.
POSSIBLE CAUSE
The air quality in the room is poor,
or the humidity level is low.
POSSIBLE CAUSE
The Humidifying Components
have not been properly cleaned or
maintained.
POSSIBLE CAUSE
The Revive requires service.
POSSIBLE SOLUTION
Remove the plastic packaging and
put the filters back in.
Contact the Brondell Service Center
at 888-542-3355.
Replace with a new filter set.
Ensure that there is clearance of 20
inches on each side and 4 inches
behind the air purifier.
Ensure the filters are placed in the
correct order (see pages 8–9).
Suggested coverage area is a
medium-to-large room.
POSSIBLE SOLUTION
Put the Revive into Fan Speed
Mode, or Manual Mode. You can
also empty the Water Tank to stop
the Revive from humidifying (see
page 15).
POSSIBLE SOLUTION
See pages 25–26 for instructions
on proper care of the Humidifying
Components.
POSSIBLE SOLUTION
Contact the Brondell Service Center
at 888-542-3355.