Solter INVERCAR 750 Manual De Instrucciones página 10

LED display
The unit is built-in with LED display for showing charger status:
1
1. REVERSE – RED LED – DC clamps are connected in reverse polarity.
2. FAULT - RED LED – Battery Fault.
3. POWER - YELLOW LED – The charger is connected to mains power.
4. CHARGING – AMBER LED – The charger is charging the battery.
5. FULL - GREEN LED – The battery is fully charged and the charger is in maintenance mode.
Temperature Compensation
A temperature sensor built in the housing of the unit will automatically adjust the charging voltage. A high
temperature environment will lower the voltage, and freezing condition is handled by higher voltage. A low
temperature heightens the output voltage, and hot condition is handled by lower voltage.
Voltage compensation
Because of some voltage drop in the cables, the actual voltage at the clamps of the battery can
be lower than the charger output voltage. A special circuitry inside the unit will monitor the true input voltage to
the battery and adjust the output voltage of the unit accordingly. This will maximize the charging efficiency.
Reverse-polarity protection
This unit offers reverse-polarity protection, the RED "REVERSE" LED will illuminate and the charging process
will not start. If this happens, unplug immediately from mains, connect the red HD75A clip to positive (+) battery
post, and black HD75A clip to negative (-) post, then plug into the mains power and the charging process will
start.
Short-circuit protection
Should you accidentally touch the HD75A clips together whilst the mains power is on, the unit will not perform
charging. Unplug from mains, disconnect and start the process again being careful not to touch the clips
together.
Hanging clip
The INVERCAR 750 is supplied with a (removable) steel hanging clip. With this clip it is easy to hang the
charger somewhere in your car or garage during charging or for storage.
Charger memory
In the event of a black-out or loss of AC power, the charger will automatically memorize the selected charging
mode. When AC power is restored, the charging will continue in the selected mode.
ATTENTION: Once the clamp of charger is disconnected from the battery, this memory is erased and the
charging mode will need to be reselected.
Other features
•
Anti Spark Protection
•
Battery and Charger Overheating Protection
•
ABS Housing.
•
Degree of Protection IP65
2 3 4 5
MI03065-04