Safety Symbols On The Meter; Maintenance - koban KPA 01 Manual De Instrucciones

KPA 01
Digital clamp multimeter
• Never connect the test leads across a voltage source while the rotary switch
is in the resistance, diode or continuity mode. Doing so can damage the
meter.
• Power off the circuit and discharge capacitors before testing capacitance.
• Do not place the meter in any environment with high pressure, high
temperature, dust, explosive gas or vapor.
• Stop using the meter if any failure or abnormal function is observed.
• Do not use meter unless battery cover is in place a secured.
• Avoid direct sunlight, exposing batteries to humidity, any strong magnetic
field, or high temperatures to ensure the extended life of the meter.

Safety Symbols on the meter

Important safety information; please refer to user manual.
High voltage.
Compliance with requirements for double insulation.
CAT III Refers to the impulse withstand voltage protection level in
accordance with IEC-61010-1 standard overvoltage (installation)
category III, pollution degree 2.
Meter complies with European Community (CE) standards
Earth ground

Maintenance

• To avoid electric shock or personal injury, repairs or servicing not covered
in this manual should be performed only by qualified personnel.
• Remove test leads before opening battery cover
• To avoid incorrect readings causing electric shock or personal injury, when
low battery symbol
• The meter can be cleaned with a soft cloth to remove any oil, grease or
grime. Do not use liquid solvent or detergent.
• When the instrument is not in use, turn rotary switch to "OFF"
• If the instrument is not to be used for an extended period of time, remove
the batteries to prevent damage to the instrument.
Instructions manual | 22
appears replace batteries immediately.
www.grupotemper.com