Auto Power Off - koban KPA 01 Manual De Instrucciones

KPA 01
Digital clamp multimeter
Function switching
1. When rotary switch is on Resistance, Diode, capacitance, and continuity
mode, press "FUNC" button to switch between those four.
2. When rotary switch is on Voltage and Current mode, press "FUNC" button
to switch between AC and DC.
ZERO/REL
1. Press "ZERO/REL" button to enter relative measurement mode. When in
this mode, the current reading will be stored and shown on the secondary
display while the main display with show the difference of current reading
and stored reading. REL Δ (Output) = (current reading) – (reading when
button pressed).
2. "REL" can only perform under manual mode.
INRUSH
When in AC Current measurement mode, press the "INRUSH" button to enter
surge current measurement mode. Press button again to return to normal
mode.

Auto Power Off

1. When not in use, the meter will automatically turn off after 20 minutes.
2. After Auto Off, press any button to bring power back on.
3. To disable Auto Off, hold "ZERO/REL" when turning on the Meter.
4. When auto power off is on, symbol
symbol does not appear.
Measuring Preparation
1. Turn on the meter by turning the rotary switch. If battery voltage is low (
3.6V), " " appears; replace the battery.
"indicates input voltage or current should not exceed the indicated
2. "
value; this is to protect the meter from damage.
3. Turn the rotary switch to the proper position.
4. When connecting to the circuit, connect COM input first before
connecting to power. Remove the power lead first when disconnecting
from the circuit.
Instructions manual | 32
appears on screen. When disabled,
www.grupotemper.com