Cramer 82B1000 Manual De Instrucciones página 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
NOTE: Always use the cable outlet at the side in which
the power tool is being held and controlled.
To reduce the risk of accidents, never lay the cable
diagonally – it may snag on objects.
CHARGING THE BACKPACK BATTERY
See Figure 7.
„ Insert the power cord plug (A) in the socket (9) on the
charger.
„ Push the power cord plug into the socket and turn
counterclockwise until the plug's latch is engaged and
secure.
„ Connecting the charger plug to the power supply.
To prevent serious personal injury, make sure the
unit is in the OFF position, it is unplugged, and the
impellers have stopped before attaching or removing
tubes.
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is misuse,
and could result in a hazardous condition, leading to
possible serious personal injury.
HARNESS ADJUSTMENT See Figure 9.
A well adjusted backpack blower and harness makes
work easier. Adjust the harness to give you the best
working stance. Adjust the side straps so the weight is
equally distributed across your shoulders.
a. Once the blower is properly fitted on your back, pull the
ends of the straps downward to tighten the harness.
b. Lift the tabs of the adjusters to loosen the straps.
c. Close and lock the quick-release fastener by pushing
it together.
d. Squeeze the hooks to open the quick-release fastener.
PUT ON THE SHOULDER STRAP
„ Adjust the harness straps (1) to the correct length.
„ Adjust chest strap (2) to correct length and fasten it
together.
HARNESS REMOVAL
„ Open the quick-release fasteners on the strap.
English (original instructions)
WARNING
WARNING
WARNING
„ Loosen the harness straps by lifting the sliding
adjusters and then take off the blower.
The backpack blower must be quickly removed in the
event of imminent danger. The chest strap must be
released before putting the backpack blower on the
ground.
OPERATION
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a sec-
ond is sufficient to inflict serious injury.
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury. Before each use,
inspect the entire product for damaged, missing, or
loose parts, such as screws, nuts, bolts, caps,etc.
Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced.
STARTING /STOPPING THE BLOWER See Figure 8.
Before start-up, make sure that the blower is in perfect
condition to guarantee safe operation.
„ Squeeze the switch trigger to start.
„ To change speed, press or release trigger by degrees
to increase or decrease the speed.
Always disconnect the product from the battery when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack
will prevent accidental starting that could cause serious
personal injury.
2
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING