Attaching Traction Unit Stand To Table - Chattanooga ADAPTA ADP400 Manual De Usuario

setup

AttAchiNg trActioN uNit stANd to tAble

Attach the Pivot Plate to the table
and fasten with the two supplied
1/4-20 screws.
NOTE: Make sure that the holes
of the Pivot Plate and the
table are aligned before
securing the Pivot Plate to
the table.
Attach the two supplied 1/4-20
ESNA nuts to each screw and
tighten with a 7/16" wrench.
Attach the Traction Unit Stand to
the aligning holes of the Pivot Plate
and the table.
13
Adapta® ADP400
Place the two supplied 13 mm
flat washers underneath the Pivot
Plate.
Attach the two supplied 9/16"
ESNA nut and tighten with a 9/16"
wrench.
Position the adjustment knob
of the Traction Unit Stand to the
desired degree of the Pivot Plate.