Mounting Traction Unit To Stand - Chattanooga ADAPTA ADP400 Manual De Usuario

setup

mouNtiNg trActioN uNit to stANd

• The traction stand is designed for Chattanooga traction
units only. Securement of other traction units need to follow
traction manufacturing recommendations. DJO, LLC is not
responsible for any consequence resulting from using products
manufactured by other companies.
• To prevent accidental disengagement, the traction unit must be
securely attached to the mounting surface of the traction stand. It is
the responsibility of the user to verify the adequacy of the
installation before use in patient therapy.
NOTE: The traction unit should be mounted facing the direction of
pull so the Traction Cord does not contact the side of the slot
from which it extends.
14
Adapta® ADP400
1. To secure the traction unit to the
traction stand, loosen the
clamp from the traction unit. Fit
the traction unit to the stand and
tighten the clamp up onto the
stand.
2. Attach the mounting screw onto
the traction stand at the front
of the unit. The mounting screw is
provided with traction units only.