Color Camera - Niko 16-601 Manual Del Usuario

MODULES

6. COLOR CAMERA 16-620

6.1. Description
The camera has an opening angle of 45°. The centre of the opening angle of the camera can be
rotated 7,5° in all directions. Thanks to a built-in LED lighting, the camera can also be used in dark
environments. The camera is used in combination with other modules from the range Access Control
Design. The camera is protected by a 4mm thick plexiglass.
6.2. Installation
Connect the flat cable and mount the module in the external unit by means of the 4 supplied screws
(see '2. Mounting the modules'). To adjust the direction or sharpness of the camera, open the camera
module by means of the 4 Allen screws at the back of the module. Gently remove the plastic cover
cap. There is some adhesive between the cover cap and the module. This could cause you some
difficulties in removing the cover cap. If this is the case, use a small screwdriver.
Loosen the big screw (fig.5a) to rotate the camera horizontally to the left or to the right. Turn the
lens enclosure at the front of the camera (fig.5b) to the left or to the right in order to adjust the
sharpness of the image. Screw-fix the screw down again. Then turn the camera up or down (fig.
5c). Close the module.
48
fig.5a
fig.5c
fig.5b
EN