Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SERVICE INSTRUCTIONS FOR LP1
SAFETY MESSAGE TO INSTALLERS, USERS AND
It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is thoroughly
familiar with the National Electric Code and will follow the NEC Guide-
lines as well as local codes.
The selection of mounting location for the device, its controls and the rout-
ing of the wiring is to be accomplished under the direction of the facili-
ties engineer and the safety engineer. In addition, listed below are some
other important safety instructions and precautions you
should follow:
• Read and understand all instructions before installing or operating
this equipment.
• Disconnect light from the power supply before any installation or
maintenance is performed.
• After installation, test the light system to ensure that it is
operating properly.
• After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
• Establish a procedure to routinely check the light installation for integ-
rity and proper operation.
• The nameplate, which may contain cautionary or other information of
importance to maintenance personnel, should NOT be obscured in
any way.
Failure to follow all safety precautions and instructions may result in
property damage, serious injury, or death to you and others.
A. General.
The Model LP1 is a UL /C-UL listed visual signal and has been
investigated by UL as meeting Type 4X (water tight and corrosion
resistant) enclosure requirements. The units are rated for operation
on 120 VAC or 24/12 VDC.
STROBE LIGHT
MAINTENANCE PERSONNEL
-1-
Publicidad
