Allmatic BIOS2 Guía Para La Instalación página 24

7.3 Input LED and safety devices
8. Technical features
POWER SUPPLY AND CONSUMPTION
Power supply voltage
Absorption from line (Standby)
Standard configuration (2 couple of photocells,
Line fuse
MOTOR POWER SUPPLY
Number of motors
Motor power supply voltage
Maximum power absorbed from motors
ACCESSORIES POWER SUPPLY
Accessories power supply voltage
Maximum current absorbed from accessories
Maximum power absorbed from accessories
Accessories fuses
Blinker output
Courtesy light output / open gate light
Electrical lock output
FUNCTIONALITY
433 MHz radio receiver
Maximum transmitters
Safety edge input
The correct functioning is guaranteed only in the event of Allmatic motors. For a greater safety, it is suggested to insert a fuse (T
9. Motors
3,15A) in series to the common of both the motors. It is available a pre-wired kit (optional) that can be inserted as shown in the
drawing below.
WEEE - Information for users: If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be
included with other general waste at the end of its working life. The user must take the worn product to a sorted waste center, or return it to
the retailer when purchasing a new one. Products for disposal can be consigned free of charge (without any new purchase obligation) to
retailers with a sales area of at least 400 m
friendly disposal of the used device, or its subsequent recycling, helps avoid the potential negative effects on the environment and people's
health, and encourages the re-use and/or recycling of the construction materials.
GUARANTEE - In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the
repair or free replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The
guarantee does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect
product, assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired.
Printed specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environ-
mental interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective
products, are only those responsibilities that come under Italian law.
6-1622189 rev.7 02/09/2019
RX radio safety edge)
Accessories 24Vdc
Accessories 24Vac
from terminal board
with R1 card (optional)
2
, if they measure less than 25 cm. An efficient sorted waste collection for the environmentally
ITA ENG FRA ESP DEU
230 Vac - 50/60 Hz
55mA @ 230 Vac
230 Vac - 50/60 Hz
2 x 700W
24Vdc - 24Vac
145 mA dc - 375 mA ac
3.5 W dc - 9W ac
230 Vac 60W max
230 Vac 100W max
12 Vac 15 VA
dry contact
230 Vac 5A, 30 Vdc 5A max
Rolling code
1000 (up to 8000)
NC / 8k2
POR
F6.3A
1 / 2
F0.5A
F2A
12 / 12