DITTING 807 Serie Instrucciones De Uso página 41

Opera on
NOTE!
Risk of overhea ng!
Exceeding the maximum permissible opera ng cycle can cause the grinder to
overheat.
– Do not exceed the maximum opera ng cycle
(see "Technical data" sec on).
– Observe the recommended break when the maximum permissible oper-
a ng cycle is reached (see "Technical data" sec on).
• The grinder has a thermal overcurrent circuit-breaker which
interrupts the electric circuit of the grinder in the event of an
electrical overload.
To put the grinder back into opera on, fi rst set the On/Off
switch (13) to switch posi on 0 (off ) and disconnect the power
plug (15).
Then push the release bu on (14) in.
You can now plug the power plug back into the socket and put
the grinder into opera on (see "Se ng up and connec ng the
grinder" sec on).
• The grinder also has a motor protector, which switches off
the grinder when the motor becomes too hot. As soon as
the motor has cooled down, the grinder can be put back into
opera on (see "Troubleshoo ng" sec on).
Se ng the grinding degree
• The grind adjustment's grinding degree scale (2) displays the
desired grinding degree.
The fi nest se ng is "1".
1. Make sure that you have inserted the power plug (15) into a properly
installed safety socket.
2. Turn the grind adjustment (2) towards "1" for fi ne coff ee grinding and in
the opposite direc on for coarse coff ee grinding (see Fig. B).
807 | EN 807
41 41