Troubleshoo Ng - DITTING 807 Serie Instrucciones De Uso

Troubleshoo ng

Problem
The grinder is • The power plug is
not grinding.
• The bean hopper
• The thermal
• The electric fuse
Cause
not plugged into a
socket.
is not
inserted.
overcurrent cir-
cuit-breaker
has been
triggered.
has
tripped.
Remedy
Insert the power plug into a prop-
erly installed wall socket.
Insert the bean hopper (see "Set-
ng up the grinder and inser ng
the bean hopper" sec on).
Check whether the circuit break-
er release bu on has popped
out. Push it back in if necessary.
If the circuit-breaker repeatedly
pops out, contact your supplier
(see "Maintenance and service"
sec on).
Check the electric fuse. Return it
to its original state or replace it.
Check whether other loads are
connected to this fuse and if so,
pull their plugs. If the fuse trips
repeatedly, contact your supplier
(see "Maintenance and service"
sec on).
807 | EN 807
49 49