DITTING 807 Serie Instrucciones De Uso página 45

Cleaning the surface underneath the grinder
1. Switch off the grinder and remove the power plug (15) from the socket.
2. Li the grinder by its casing with both hands and place it on another sur-
face that is clean.
3. Use a damp cloth to clean the surface on which the grinder is used and
the underside of the grinder (par cularly the feet of the unit); then dry
both surfaces.
They must be dry and free from oil and grease.
4. Place the grinder back onto the cleaned surface.
Cleaning the casing
1. Switch off the grinder and remove the power plug (15) from the socket.
2. Use a brush to clean the following parts:
• Spout (6),
• Folding table (9),
• Spout guide (10),
• Filter basket holder (11),
• Adjus ng screw Folding table (22), Filter basket holder adjus ng screw
(25) and Spout guide adjustment (23).
3. Wipe the casing and the collec ng tray (4) with a damp cloth as necessary,
but at least once a week.
807 LAB SWEET Cleaning the folding table:
1. Loosen the adjus ng screw (22) underneath the folding table and pull off
the folding table (9) downwards from the rail (8).
2. Remove the an -slip mat from the folding table.
3. Clean the folding table with a brush.
4. Clean the folding table and the an -slip mat with a damp cloth and then
dry them.
5. Clean the rail with a damp cloth and then place the folding table back onto
it.
6. A er adjus ng to the desired height, secure the adjus ng screw.
7. Put the an -slip mat back on the folding table.
807 | EN 807
45 45