Replacing The Rack Doors; Installing The Tray And Cable-Management Arm (Sliding Rail Kits Only); Installing The Tray - Dell POWER EDGE 1950 Guia De Instalacion

Replacing the Rack Doors

See the procedures for replacing doors in the documentation provided with your rack.
CAUTION:
Because of the size and weight of the rack cabinet doors, never attempt to remove or install them
by yourself.
Installing the Tray and Cable-Management Arm
(Sliding Rail Kits Only)
NOTE:
This procedure does not apply to the static rail kit.

Installing the Tray

1 At the back of the system, fit the ends of the tray between the ends of the mounting rails and slide
the tray forward until it latches (see Figure 1-12).
2 In preparation for installing the cable-management arm, press the catch at the center of the cable-
management arm retention latch and rotate the latch downward (see Figure 1-12).
Figure 1-12. Installing the Tray
1 mounting rails (2)
22
Four-Post Rack Installation
back of system
2 tray
1
3 cable-management arm retention latch
2
3