Touch Display - Stoelting C111-37 Manual Del Propietário

MAIN SWITCH
The main power switch is located on the top of the machine at
the back.
Its function is as follows:
Position 0 : machine is off
Position I : machine enabled for operation but in Standby
mode. Only indicator light Q is on.
IMPORTANT
If you turn the machine off and back on at the main power
switch, it will restart in the same operating mode it was in
when it was switched off.
ON/OFF BUTTON
The ON/OFF button P is located to the right of the touch display.
If indicator light Q comes on, the machine is switched on and in
standby mode, ready for operation. Hold down the ON/OFF but-
ton for one second to turn the machine on and off.

TOUCH DISPLAY

The following icons appear on the display:
A SOFT serve PRODUCTION icon; when pressed, the
SOFT serve function is enabled.
B NIGHT MODE icon; when pressed, the NIGHT MODE
function is enabled
C WASHING icon; when pressed, the WASHING function is
enabled.
D PARAMETERS icon; when pressed, adjustments can be
made to the operating PARAMETERS.
E Alarm code. Indicates an alarm and displays the relevant
code.
F Consistency bar. Indicates the set consistency level.
G Mix temperature. Indicates the mix temperature in the hop-
per.
figure 8
H Status icon. Indicates the machine status (soft serve, night
mode, washing, alarm) and the soft serve preparation sta-
tus when the soft serve mode is enabled:
red icon: soft serve not ready
yellow icon: soft serve almost ready
green icon: soft serve ready
I Hopper cooling icon. Indicates that the hopper cooling is in
operation.
J Freezing cylinder cooling icon. Indicates that the freezing
cylinder cooling is in operation.
K Compressor icon. Indicates the compressor is in opera-
tion.
L Display shut-down icon. Indicates that the touch display
has shut down and no controls can be accessed.
FOR MACHINE OPERATION
Turn the main power switch to position I. Red indicator light Q
comes on.
Hold down button P until the machine starts up again.
Select the desired function using icons A, B, c or D.
SOFT SERVE MODE
In this operating mode, the machine produces soft serve and the
mix in the hopper is kept at a suitable temperature to preserve
it. The soft serve preparation status is indicated on the display
by the central icon and by the color of the arrows.(see figure 9)
When the soft serve is ready, the auger slows down, the cooling
system stops and the machine switches to serve mode. At de-
fault intervals (factory set to every 10 minutes), the auger in-
creases speed and the cooling system runs to restore the proper
soft serve consistency.
When the spigot is opened, the auger speed increases and the
cooling system runs.
In order to produce soft serve, the hopper must contain a suit-
able quantity of mix. If the mix level gets low, the central icon dis-
plays low product.(see figure 10)
Consistency adjustment
The consistency of the soft serve can be adjusted on a scale of
1 to 10. To adjust, touch the graduated bar on the right-hand
side of the touch display. The following controls are available:
A Exit icon: Exits without making any changes.
B Decrease icon: Decreases the consistency value.
C Increase icon: Increases the consistency value.
D Confirm icon: Confirms the value set.
5
figure 9
figure 10