Daily Maintenance; Charging Batteries - NSS CHARGER 2022 ABLT Instrucciones Originales

MAINTENANCE
ALWAYS turn OFF all machine switches
before performing any maintenance or
repairs to any equipment.

Daily Maintenance

Pad Installation / Changing
There is a wide range of pads available for many
different burnishing applications. Consult your local NSS
authorized distributor for application recommendations.
 Lift the front of the machine up to the 90° position to
view the pad driver and pad.
 Make sure that the correct pad size is installed. The
Charger 2022 ABLT requires a (7/8" to 1") X 20"
[(22mm to 25mm) X 50.8cm] pad.
 Remove the center of the pad and place the pad flat
on the floor. Step on the center of the pad to
compress the edges around the center hole. This
allows for easier installation of the pad centering cup.
 With the machine in the pad changing position,
carefully center the pad on the driver.
Caution: Pads must be installed concentric (evenly
aligned) with the outside edge of the pad driver. Failure
to follow these precautions will cause excessive
machine vibration, a reduction in pad life and produce
unsatisfactory burnishing results.
 Place the pad grabber in the center hole of the pad.
 Holding the pad driver and pad, push on the pad
grabber until the spring clip has clicked twice.
Caution: Failure to install the pad grabber tightly may
allow the pad to be thrown from the driver.
Empty the dust collection bag daily.
 Empty the filter bag daily or when it is approximately
one-half (1/2) full.

Charging Batteries

 Recharge the batteries when indicated by the Battery
Meter.
 Never let the batteries sit overnight after the machine
has been run for 1hr or more since last recharge.
 NEVER let the electrolyte level fall below the tops of
the plates. This will damage the batteries
immediately, and void the warranty.
 Check charger cord for exposed wires and damaged
plugs before using.
 To recharge the batteries plug the charger cord into
the charger and then into an electrical outlet. See the
above picture.
 When the cord is plugged into an outlet the machine
will automatically become disabled or turn off.
 Charge the batteries with the cover open when
possible to reduce heat buildup in the batteries.
 See charging instructions for more details.
Check water level in batteries daily
 ALWAYS wear eye protection, rubber gloves and
protective clothing to avoid contact with battery acid
when working around batteries.
 After charging batteries check the water level of each
battery cell and add distilled water as required to level
specified by battery manufacturer.
 Check and verify that all battery connections are
clean and tight.
 Wipe machine down with a damp cloth.
 NEVER spray this machine with water or any liquids.