Manual Mode; Operate Watering Program(S); T Operate Stations - Toro TMC-212 Manual Del Usuario

Note: The position of the
PROGRAMS
determine which program will run during automatic
controller operation. In other words, if a program has an
assigned watering day schedule, start time and a station
with run time, it will operate automatically regardless of
the position of the
PROGRAMS

Manual Mode

Manual mode enables automatic watering programs and
their assigned stations to be operated at any time.
Note: Once watering has started, see page 32 for addi-
tional manual control operations.
Note: Upon completion of a Manual mode operation, the
controller will return to the Automatic mode.

Operate Watering Program(s)

Confirm the control dial is in the
Position the
PROGRAMS
Press the
MANUAL START
program watering cycle. The first active station num-
ber and the Watering On
ing.
4. To select additional programs, repeat steps
Note: Additional programs are stacked (staged to
run sequentially) in the order they are selected.
The watering program identifier (A, B or C) will be
displayed as each program is selected. The program
currently operating is indicated by the flashing pro-
gram identifier. As one program finishes the next
program in queue will start.
switch does not
switch.
position.
RUN
switch to select a program.
button two times to start the
symbol will begin flash-
and
1
Operate Selected Stations
Confirm the control dial is in the
Position the
PROGRAMS
Press the
MANUAL START
The station numbers assigned to the program will be
displayed. The first station number in sequence will
begin flashing. To select the station(s) to operate,
use the following procedure:
• To select the station, press the +/
.
• To skip the station press the –/
When the desired station numbers are displayed,
press the
MANUAL START
ing. The active station number and the
Watering On symbol will begin flashing.
Flashing
4
3 5
4
position.
RUN
switch to select a program.
button one time.
button.
ON
button.
OFF
button one time to start water-
31