Manual Adjustment; Electronic Adjustment; Use Of Dishwasher Salt - Electrolux FAVORIT OPTIMAAA Manual De Instrucciones

8

Use of dishwasher salt

Manual adjustment

The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights for function buttons
A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A continues to flash.
– The indicator lights for function buttons B and C go off.
– The end-of-programme indicator light starts to flash.
The setting function of the water softener is activated.
The end-of-programme indicator light flashes to show the level of the water softener.
The pause is approximately 5 seconds.
Example: 5 flashes, pause, 5 flashes, pause, etc. = level 5
6. Press the function button A one time to increase the water softener level by one step.
7. Press the on/off button to save the operation.
Use of dishwasher salt
CAUTION!
Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause dam-
age to the water softener.
CAUTION!
Grains of salt and salty water on the bottom of the appliance can cause corrosion. Fill the
appliance with salt before you start a washing programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the salt container.
2. Fill the salt container with 1 litre of water (only the first operation).