How To Check The User Pin Brute Force Limitation - iStorage DISKASHUR M2 Manual Del Usuario

Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

34. How to check the User PIN Brute Force Limitation

The Administrator is able to observe and determine the number of consecutive times an incorrect User PIN is allowed to be entered
before triggering the Brute Force defence mechanism by simply noting the LED sequence as described below.
To check the brute force limitation setting, fi rst enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
2 + 0 buttons
2. Press the KEY ( ) button and the following happens;
a. All LED's (RED, GREEN & BLUE) become solid for 1 second.
b. Each RED LED blink equates to ten (10) units of a brute force limitation number.
c. Every GREEN LED blink equates to one (1) single unit of a brute force limitation number.
d. All LED's (RED, GREEN & BLUE) become solid for 1 second.
e. LEDs return to solid BLUE
The table below describes the LED behaviour whilst checking the brute force limitation setting, for instance if you have set the drive to
brute force after 5 consecutive incorrect PIN entries, the
Brute Force Limitation Setting
2 attempts
5 attempts
10 attempts
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
GREEN LED will blink fi ve (5) times.
RED
0
0
1 Blink
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
Solid BLUE LED will change to blinking
BLUE LEDs
GREEN
2 Blinks
5 Blinks
0
GREEN and
#25