CAMPAGNOLO BRAKES Manual Del Usuario página 23

4 - REPLACING THE BRAKE PADS
• To replace the brake blocks remove the
screw on the brake block holder (F - Fig. 10)
using a 2 mm Allen wrench, remove the worn
F
brake block (Fig. 10) and replace it with a
new one.
• Insert the new brake block, ensuring that
the wheel direction arrow on the brake block
is in the actual forward direction of the wheel.
• Ensure that the seat (G - Fig. 10) of the brake
block screw is in the position that corresponds
to the locking screw on the brake block holder
(Fig. 10).
DANGER!
F
Fully tighten the screw on the brake block
holder using a 2 mm Allen wrench.
Incorrect mounting of the brake block
holder may cause the brake block to slide
G
out of the brake block holder and cause
accidents, physical injury or even death.
• Ensure that the distance of the pads from
the wheel is about 1 mm (Fig.3).
10
ENGLISH 23