Atlantic 2012 Serie Manual De Uso página 26

Problems Encountered
The indicator light B
flashes.
The surface of the
device is very hot.
The last elements, top
and bottom, are more
tepid than the rest of
the device
24h Auto mode does
not repeat every day.
The device does not
follow the programming
instructions
Repetition of 24h Auto
mode does not start at
the desired time.
i
n CaSe oF ProBLem
You have locked the device and someone has tried to alter its operating
mode.
- Either unlock the device to stop the light from flashing and reprogramme
it for the desired function,
- Or check the position to which the mode selection wheel a has been
set:
- If it is set to 24h auto heating, set it to on or 24h auto drying.
- If it is set to on, set it to 24h auto heating or 24h auto drying.
- If it is set to 24h auto drying, set it to on or 24h auto heating.
The light will stop flashing when you set the mode to the position where
it had initially been locked.
Your room temperature is below 3°C. We recommend that you put your
device in Frost mode to avoid any risk of damage to your room.
It is normal for the device to be hot when it is operating; the maximum
surface temperature is limited in accordance with the prevailing standard.
If, nevertheless, you think your device is always too hot, check that the out-
put is suitable for the size of your room (we recommend 50W / m
the device is not located in a draft interfering with its automatic controls.
The last elements, top and bottom, are more tepid than the rest of the
device.
- In the case of the top one, the upper elements are not completely filled
to allow for expansion of the thermodynamic fluid. They heat up only by
conduction.
- In the case of the bottom one, the lower elements channel the returning
fluid after it has transmitted its heat.
- Check that the electricity supply has not been interrupted at any time.
The position of the mode selection wheel a may have been changed
(refer to the section on page 20).
- Check that the wheel a was not set to oFF.
- Ensure that the programmer is being used correctly (please refer to the
User's Manual).
- Check whether the electricity supply has been cut off at any time.
- Check whether there has been a changeover from Summer to Winter
time or vice versa.
- Check that the wheel a was not set to oFF.
Checks to be made
25
gB
) and that
3