Advanced Menu List - DeVilbiss Healthcare SleepCube DV54 Serie Manual Del Usuario

EN

Advanced Menu List

Display Example
P: 5.0
Heat:Off
Upper Limit
15.0 cmH2O
Lower Limit
5.0 cmH2O
Set Pressure
10.0 cmH2O
Delay Time
45 minutes
Delay Pressure
5.0 cmH2O
Tubing Length
1.8 m (6 ft)
SmartFlex Menu
Press 
Enable Menu
Press 
LCD Contrast Adj
50 %
SE-DV54-1
14
aDVancED mEnu controlS
Mode
All
Auto
turned on. The actual mask pressure and heater
setting are shown. The displayed pressure may
vary slightly while breathing. If the heater system is
not connected, the heat setting will be blank.
AutoAdjust
maximum pressure at which the SleepCube will
Mode
operate if in AutoAdjust mode. Your home care
provider programs this setting for you during
device setup.
AutoAdjust
minimum pressure at which the SleepCube will
Mode
operate in AutoAdjust mode. Your home care
provider programs this setting for you during
device setup.
CPAP
operating pressure.
Mode
All

the delay time.
CPAP
operating pressure during the delay time.
Mode
All

device is 6 feet (1.8 meters). However, you can
adjust your SleepCube to accommodate an air
supply tubing length of 10 feet (3.0 meters).
Replacement tubing can be obtained through your
home care provider (part numbers listed at the
end of this manual).
All
Refer to SmartFlex Menu section for details.
All
Refer to next section for Enable Menu details.
All
display. This only needs to be adjusted if you find it
difficult to see the display from your viewing angle.
Description
This is the default screen when the SleepCube is
This is a prescription setting which limits the
This is a prescription setting which sets the
This is a prescription setting which controls the
Selectable delay time setting. Your provider has set
This is a prescription setting which controls the
The standard tubing length supplied with the
Pressing the down key enters the SmartFlex menu.
Pressing the down key enters the Enable menu.
This setting changes the contrast for the LCD