• The pilot flame can be seen through the peep hole on the
control panel.
• The pilot burner can be lit by passing a flame through the
bullseye on the bottom of the appliance.
Main burner ignition
• Turn the knob to the chosen temperature setting for cooking.
Switching off
To switch the main burner off, turn the knob to position "
To switch off the pilot flame, press and turn the knob to position
"
".
13 USING THE ELECTRIC BAIN MARIE
REMINDERS FOR USE
• The appliance is designed for indirect cooking of foods in co-
oking receptacles and for keeping food warm in a bain marie.
• Do not activate the heating system when there is no water in
the well.
• While the appliance is on, the water level must be maintained
level with or above the minimum level indicated on the wall
of the well.
• The appliance is equipped with a manual reset safety ther-
mostat which interrupts heating when the operating tempera-
ture exceeds the maximum permitted value.
• At the end of each day, clean the well thoroughly in order to
prevent the formation of corrosive deposits.
FILLING AND EMPTYING THE WELL
Filling
• Insert the overflow pipe in the drain hole of the well.
• Fill the well until the water is level with the maximum level in-
dicated on the wall of the well. Do not use the appliance with
the water level above the maximum indicated level.
Fillingwithbutton
• Insert the overflow pipe in the drain hole of the well.
• The water will come out from distributor.
• Fill the well until the water is level with the maximum level in-
dicated on the wall of the well. Do not use the appliance with
the water level above the maximum indicated level.
Emptying
Remove the overflow pipe from the drain hole of the well.
SWITCHING ON AND OFF
The control knob has the following positions:
0 Off
1 On
The thermostat control knob has the following positions:
Off
30 Minimum water temperature
90 Maximum water temperature
Switching on
• Turn the knob to position "1" ".
6
• Turn the thermostat knob to the chosen temperature setting
for cooking.
• The yellow indicator light switches on.
• The yellow indicator light switches off when the oven reaches
the set temperature.
Switching off
• Turn the thermostat knob to position "0".
• Turn the knob to position " 0 ".
".
14 USING THE POTATO WARMER
REMINDERS FOR USE
• Appliance works without water. Foods are heated directly in
the removablec ontainer supplied with the appliance.
Appliance with hot surfaces!
• The capability of the lamp to store and even out the heat also
keeps it hot for a long time after switching it off.
Operation of well
The thermostat control knob has the following positions:
0 Off
30 Minimum temperature
90 Maximum temperature
Switching on
• Turn the knob to the chosen temperature setting.
Operation of infrared heating
The control knob has the following positions:
0 Off
1 On
Switching on
• Turn the knob to position "1" ".
• Lighting up of indicator ( if present) signals that the appliance
is on and heating is by an infrared lamp (heating element).
Switching off
• Turn the thermostat knob to position "0".
• Turn the knob to position " 0 ".
EMPTYING OF CONTAINER
• Take off container from appliance.
• To do this follow this indications: protect hands from heat (for
example using suitable gloves); protect body from accidental
hot sprinkles during lifting, transport and emptying of contai-
ner.
• The container where hot foods are emptied must be large
enough and of heat resistant material.
15 PROLONGED DISUSE
Before any prolonged disuse of the appliance, proceed as fol-
lows:
• Clean the appliance thoroughly.
• Rub stainless steel surfaces with a cloth soaked in Vaseline
oil to create a protective film.
• Leave lids open.
• Shut off taps and main switches upline of appliances.
Following prolonged disuse, proceed as follows: