Replacing The Battery; Troubleshooting; Cleaning And Care - MELINERA HG04445A Instrucciones De Utilización Y De Seguridad

Note: If the ON / OFF switch is set to ON, the
product will automatically switch on at dusk. The
RGB LED at the end of the top stake
produce a colour flow lighting effect which flows
from the fibre optics of the decorative trim
to the tips of the buttlerfly's wings.
Switch the product off (OFF position) if the
product will be in the dark for extended periods
(e.g. when transporting with the battery inserted).
Setting the switch to OFF will disable the product
and charging.

Replacing the battery

(Fig. B + C)
The battery is a wear part and should be replaced
regularly (about every 1–2 years).
Since in central Europe the product is unable to
absorb sufficient energy during the winter months
due to poor sunlight, the product should be stored

Troubleshooting

Problem
The light does not come on in
the dark, even after being ex-
posed to sunlight all day.
The light only comes on for a
short time or not at all.
This product has some very sensitive electrical parts.
That is why interference may occur if the product
is set up near devices that transmit radio signals.
Remove these devices if interference occurs.
Electrostatic discharge may possibly cause distur-
bances to the product. If such disturbances occur,
remove the rechargeable battery for a few seconds,
then reinsert it (see "Replacing the battery").
away during this time. When doing so, remove the
battery for safety purposes.
Note: For this step you will need a cross-tip screw-
will then
2
driver.
1
Cause
Artificial sources of light such as
street lights, etc. are simulating
daylight to the photosensor.
The battery is drained.
There is not enough daylight to
recharge the battery.
The solar cell is dirty.
Clean the solar cell
can significantly reduce the product's performance.
Switch the product off using the ON / OFF
switch before removing or inserting the
7
rechargeable battery.
Disconnect the lower stake
standpipe (with LED) with solar housing
Open the battery compartment
underside of the solar housing
unscrew all screws with a cross-tip screwdriver,
turning counter-clockwise (Fig. B).
Carefully remove the housing cover. Ensure that
you do not damage the wiring.
Then remove the used battery.
Insert a rechargeable battery type Ni-MH, AAA,
1.2 V / 300 mAh into the battery compart-
ment . When doing so, note the polarity
8
indicated in the battery compartment.
Close the battery compartment as described
above.
Solution
Place the product in a location
where it is shielded from artificial
sources of light.
Replace the rechargeable battery!
Place the product in a sunnier
location!
Clean the solar cell!

Cleaning and care

regularly. A dirty solar cell
3
Only use a dry, lint-free cloth for cleaning.
If the product is more severely soiled, you may
have to use a slightly damp cloth and a mild
detergent.
from the upper
5
.
2
on the
8
. To do so,
4
GB/MT 23