User Interface Board - Xylem 3AB2 Manual De Instrucciones

Drive
Settings
Pressure
Adjust
Controller
Status
Indicator
Transducer
Input
Typical Motor Nameplate Showing Service Factor Amps (SF AMPS)
In this example, if controller is supplied with 208 V ,
use the 4.2 Amp Motor Overload Setting that is closest
to 4.2A without going over. For 230V input, use the setting
that is closest to 4.0A without going over.
6
Transducer
Jumper
Figure 3: UIB (User Interface Board)
Service Factor Amps (SF AMPS)
that are used to set the Motor
Overload Setting Dial.
Switch
Input
Indicator
Switch
Input
Figure 4: Typical Motor Nameplate