Tabla De Contenido; Owner's Information - Xylem 3AB2 Manual De Instrucciones

Owner's Information

Owner's Information
Controller Model Number:
Controller Serial Number:
Pump Model Number:
Pump Serial Number:
Motor Model Number:
Motor SFA:
Tank Serial Number:
Installer:
Installer Telephone Number:
Installation Date:
Wire Lengths (Feet)
Service Entrance to Controller:
Controller to Motor:
Incoming Voltage:
NOTICE: RECORD THE MODEL NUMBERS
AND SERIAL NUMBERS FROM THE
PUMP AND CONTROLLER IN THIS
INSTRUCTION MANUAL FOR FUTURE
REFERENCE. GIVE IT TO THE OWNER
OR AFFIX IT TO THE CONTROLLER
WHEN FINISHED WITH THE
INSTALLATION.
Tested to 508C and CSA 22.2,
14-95 Standards By Canadian
®
Standards Association
C US
File #LR38549
PLEASE USE THIS CONTROLLER INSTALLATION, OPERATION AND TROUBLESHOOTING
MANUAL (IOM) IN CONJUNCTION WITH THE PUMP IOM. THE CONTROLLER IOM COVERS THE
CONTROLLER ELECTRICAL INSTALLATION AND ANY SPECIAL INSTALLATION PROCEDURES
REQUIRED WITH VARIABLE SPEED CONTROLLERS.
XYLEM WILL NOT BE RESPONSIBLE FOR ANY DAMAGES TO ANY INSTALLATION WHERE THE
PRESSURE RELIEF VALVE IS ALLOWED TO DISCHARGE INTO A FINISHED LIVING SPACE OR TO
OTHERWISE DAMAGE A CUSTOMERS PROPERTY. PLUMBING SAFETY DEVICES SUCH AS PRESSURE
RELIEF VALVES TO AN APPROPRIATE DRAIN IS THE RESPONSIBILITY OF THE INSTALLER AND IS
OUT OF OUR CONTROL.
2
Table of Contents
Table of Contents
SUBJECT
1. Safety Instructions ..................................................... 3
Ratings ...................................................................... 3
Required Materials .................................................... 3
2. Typical Installation .................................................... 3
Controller ............................................................... 3-4
Pump and Piping ........................................................ 4
Tank Sizing and Tank Pressure Setting ........................ 4
Wiring - Transducer, Motor, etc. ............................ 4-6
User Interface Board .................................................. 6
3. Installer Pre-Start Selections ...................................... 7
Minimum Frequency (Speed) Switch .......................... 7
Dry Run Restart ......................................................... 7
Low Pressure Cut-Off ................................................ 7
Pressure Drop ............................................................ 7
Motor Overload Setting Dial ..................................... 7
Pressure Adjustment Pushbuttons ............................... 7
Controller Status Indicator ........................................ 7
Purging System, Adjusting Pressure ............................ 7
Checking Rotation, Check for Leaks .......................... 8
4. Switch Input Options ............................................. 8-9
5. Insulation and Winding Resistance Tests .................... 9
6. Advanced Settings / Options ................................. 9-11
7. Troubleshooting, Fault Codes ............................. 12-14
Limited Warranty ........................................................ 16
PAGE