Installing The Fan - Fanaway EVO1 LED Manual De Instrucciones

Fanaway EVO1 LED Installation Instructions
1. Installing the down rod
1) Feed the down rod (5) through the canopy (4) and the bolt and pin cover (6).
2) Remove the ball joint by loosening the set screw (3), insert the motor wires through the down rod then
secure the ball joint back to the down rod.
3) Insert the down rod to the coupling (7), line up the coupling holes with the down rod holes and insert the
bolt (8). Then insert the pin (9) to the end of the bolt.
4) Finally secure the down rod and coupling by tightening the two set screws (10) on the coupling. Fig. 4
2. Carefully lift the fan and place the down rod ball assembly into the spacing allocated in the mounting bracket
and lock the ball into place. Insert the LED driver into the lower layer of the mounting bracket then insert the
remote receiver into the top layer of the mounting bracket. Fig.4
3. Refer to the wiring diagram provided for Electrical Connection/installation. Fig. 5
WARNING: To prevent electrical shock or risk of fire, do not attempt to perform the electrical connection wiring
yourself. All electrical connections must be carried out by a licensed electrician.
NOTE: An additional all pole disconnection switch must be included in the fixed wiring.
5 | P a g e

INSTALLING THE FAN

Fig. 4
Fig. 5
V 1 . 0