Installing The Fan; Hanging The Fan - Fanaway Corbelle Instrucciones De Instalación

Fanaway Corbelle Installation Instructions
INSTALLING THE DOWN ROD (Fig. 4)
Remove the ball joint (2) and dowel pin from the down rod (5) by loosening the set screw (3).
1.
Do not discard keep these parts, they are required to reassemble later.
Feed the wires and plug (1) through the down rod (5).
2.
Insert the down rod (5) into the down rod coupling housing (7), line up the down rod coupling housing
3.
holes with the down rod holes and insert the lock pin (8) and secure with the hatch pin (9).
Secure the down rod (5) by tightening the two set screws (10) on the coupling (7).
4.
Slide the cover (6) over the down rod (5) to cover the down rod coupling housing (7).
5.
Slide the canopy (4) over the down rod (5).
6.
Install the ball joint (2) and dowel pin back onto the down rod (5) and secure by tightening the set screw
7.
(3).
Lift the fan assembly onto the mounting bracket. Ensure the key slot (A) of the hanger ball is positioned on
the key pin (B) of the mounting bracket (C) to prevent the fan from rotating when in operation. (Fig. 5)
6 | P a g e

INSTALLING THE FAN

HANGING THE FAN

Fig. 4
Fig. 5