Craftsman 124.3299 Manual Del Operador página 5

C. After the table is installed use a square to make sure that is 90
degrees to the blade (See FIG. 3).
E. Install the table leveling hex socket screw, washer and nut (See
FIG. 5).
G. To ensure upright stability, four holes are provided in the base to
allow the saw to be bolted to a bench (See FIG. 7).
Table Bolts
(x4)
I. To center the blade in the table, locate four bolts and four washers
used to mount the table. Loosen the bolts and center the table by
hand. Tighten the four bolts to retain adjustment (See FIG. 9.)
Square Table
to Blade
FIG. 3
FIG. 5
FIG. 7
FIG. 9
FIG. 4
D. Next, set the degree pointer until it reads zero degrees. Using a
Phillips screw driver loosen the pointer and set pointer to zero (See
FIG. 4).
FIG. 6
Metal Receiver
F. Insert the blade tension handle into the metal receiver protruding
from the top of the saw (See FIG. 6).
FIG. 8
H. Slide the miter gauge into the miter gauge slot in the aluminum
table (See FIG. 8).
5
Blade Tension
Handle
Miter Gauge
Miter Gauge Slot