Preselecting The Speed; Operating Informations - Flex XC 3401 VRG Instrucciones De Funcionamiento

! NOTE
Following a power failure, the switched
on power tool does not restart.

Preselecting the speed

 To set the operating speed, move the
dial (Dial for preselecting the speed)
to the required value.
 Gently press the switch (Switch) to
accelerate the power tool up to the
preselected speed.
NOTE
If an overload or overheating occurs
during continues operation, the power
tool auto-matically reduces the speed
until the power tool has cooled down
adequately.
Attach or change tools
1. Pull out the mains plug.
12
!
2. Firmly press polishing material,
centred on the eye, onto the Velcro
pad (Housing). Use undamaged
polishing tools only.
3. Insert the mains plug into the socket.
4. Switch on the polisher (without
engaging it) and run the polisher for
approx. 30 seconds. Check for
imbalances and vibrations.
5. Switch off the polisher.

Operating informations

When the polisher is switched off, the
polishing tool continues running briefly.
Following a tool change (e. g. wool pad
instead of polishing sponge), the
difference in weight may increase the
vibrations. Change the operating speed
with the adjusting wheel (9) until the
vibrations have been reduced.
 Switch on the machine before placing
it on the surface which is to be
polished and run the polisher up to
the set speed.
 Applying light contact pressure, move
the polisher in circular, overlapping
Polisher XC 3401 VRG
CAUTION
NOTE