Specific Safety Rules And Symbols - Flex XC 3401 VRG Instrucciones De Funcionamiento

(b) Tool service must be performed only
by a FLEX authorized service center.
Service or maintenance performed by
unqualified personnel could result in a risk
of injury.

SPECIFIC SAFETY RULES AND SYMBOLS

 This electric power tool must be used
as a polisher. Observe all safety
information, instructions, diagrams and
data which you receive with the power
tool.
If you do not observe the following
instructions, an electric shock, fire and/
or serious injuries may occur.
 This electric power tool is not suitable
for use as sander, with sandpaper,
wire brushes or for cut-off grinding.
If the electric power tool is not used as
intended, the user may be exposed to
hazards and may be injured.
 Never use accessories which the
manufacturer did not intend or
recommend especially for this
electric power tool.
Just because you can attach the
accessory to your electric power tool
does not guarantee safe use.
 The permitted speed of the insertion
tool must be at least as high as the
maximum speed indicated on the
electric power tool.
An accessory which rotates faster than
permitted may shatter and fly off.
 Outer diameter and thickness of the
insertion tool must correspond to the
dimensions of the electric power tool.
Incorrectly measured insertion tools
cannot be adequately shielded or
controlled.
6
(c) When servicing a tool, use only
identical replacement parts. Follow
instructions in the Maintenance section of
this manual. Use of unauthorized parts or
failure to follow Maintenance Instruction
may create a risk of electric shock or
injury.
 Sanding discs, sanding pads or other
accessories must fit exactly on the
grinding spindle of your electric power
tool.
Insertion tools, which do not fit exactly
on the grinding spindle of the electric
power tool, rotate unevenly, vibrate
violently and may result in loss of
control.
 Do not use any damaged insertion
tools. Before use, always check
insertion tools for splinters and cracks,
sanding pad for cracks, wear and
severe abrasion. If the electric power
tool or the insertion tool is dropped,
check for damage or use an
undamaged insertion tool. When you
have checked and inserted the tool,
ensure that you and anybody in the
vicinity remain outside the plane of the
rotating insertion tool and leave the
power tool running for one minute at
maximum speed.
Damaged insertion tools usually break
during this test time.
 Wear personal protective equipment.
Depending on the application, wear
full face protection, eye protection or
goggles. If appropriate, wear a dust
mask, hearing protection, protective
gloves and/or a special apron which
protect you from small sanding and
material particles.
You should protect your eyes from
foreign objects which are ejected for
Polisher XC 3401 VRG