Safety Warnings Specific For Polishing Operations; Additional Warnings - Flex XC 3401 VRG Instrucciones De Funcionamiento

The operator can control torque
reactions or kickback forces, if proper
precautions are taken.
 Never place your hand near the
rotating accessory.
Accessory may kickback over your
hand.
 Do not position your body in the area
where power tool will move if kickback
occurs.
Kickback will propel the tool in direction
opposite to the wheel's movement at
the point of snagging.
 Use special care when working
corners, sharp edges etc.
Avoid bouncing and snagging the
accessory.
Corners, sharp edges or bouncing
have a tendency to snag the rotating
accessory and cause loss of control or
kickback.
 Do not attach a saw chain, wood-
carving blade or toothed saw blade.
Such blades create frequent kickback
and loss of control.
Safety Warnings Specific for
Polishing Operations
 Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings.
Loose and spinning attachment strings
can entangle your fingers or snag on
the workpiece.
Double insulation for safer operation
To ensure safer operation of this power
tool, FLEX has adopted a double
insulation design.
means that two physically separated
insulation systems have been used to
insulate the electrically conductive
materials connected to the power supply
from the outer frame handled by the
8
"
Double insulation
operator. Therefore, either the symbol
or the words
on the power tool or on the nameplate.
Although this system has no external
grounding, you must still follow the
normal electrical safety precautions
given in this Instruction Manual, including
not using the power tool in wet
environments.
To keep the double insulation system
effective, follow these precautions:
 Only FLEX AUTHORIZED SERVICE
CENTER should disassemble or
assemble this power tool, and only
genuine FLEX replacement parts
should be installed.
 Clean the exterior of the power tool
only with a soft cloth moistened with
soapy water, and dry thoroughly.
 Never use solvents, gasoline or
thinners on plastic components;
otherwise the plastic may dissolve.

Additional warnings

 Some dust created by power
sanding, sawing, grinding, drilling and
other construction activities contains
chemicals known to the State of
California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals
are:
– Lead from lead-based paints.
– Crystalline silica from bricks, cement,
and other masonry products.
– Arsenic and chromium from
"
chemically-treated lumber.
Your risk from these exposures varies,
depending upon how often you do this
Polisher XC 3401 VRG
"
Double insulation
"
appear