Nice ETWI Instrucciones Y Advertencias De Instalación Y Uso página 8

TABLE B - Dip-switch settings and functions
1 2 3 4
ON – – –
OFF – – –
– ON – –
– OFF – –
OFF OFF
– –
– – OFF ON
– – ON OFF
– – ON ON
NOTE – The dip-switches 1, 2, 3 and 4 are set in factory with the option OFF ("Test" function disabled; address "0";
WIEGAND mode with 26 bit).
7 – English
Function
"Test" function activated
Normal operating mode. In
this circumstance the "Test"
function is disabled
Address for ETWI: 1
Address for ETWI: 0
WIEGAND mode: 26 bit
WIEGAND mode: 30 bit
WIEGAND mode: 34 bit
WIEGAND mode: 37 bit
The relay and LED of ETWI are activated for 3 seconds every time ETWI re-
ceives the radio code of a compatible transmitter, regardless of the consent
sent by the control unit to the INP terminal. The message is nevertheless sent
on the WIEGAND bus according to the selected mode. • For further details on
how the message is structured, refer to Chapter 5, of this manual.
When ETWI detects a radio transmission coming from one of the transmitters
memorised in the control unit, it will send a message on the WIEGAND bus con-
taining the code of the transmitter, the pressed button and the current address
set using dip-switches. • For further details on how the message is structured,
refer to Chapter 5, of this manual.
It is possible to connect up to two ETWI on the same WIEGAND line, one with
address 0 and one with address 1. The value of the set address will be subse-
quently included in the message sent on the WIEGAND bus. • For further details
on how the message is structured, refer to Chapter 5, of this manual.
Select the length (expressed in bit) of the WIEGAND message to be transmitted.
The factory-set mode (26 bit) is compatible with the vast majority of control units
available in the market. If necessary, you can select one of the other modes
available. • For further details on how the message is structured, refer to Chap-
ter 5, of this manual.
Description