Troubleshooting - Samsung POWERbot SR2AK9350W Serie Manual Del Usuario

troubleshooting

Symptom
the PoWeRbot is not
working at all.
the PoWeRbot has stopped
during cleaning.
Suction power is weak.
the PoWeRbot cannot find
the docking station.
the PoWeRbot suddenly
cleans diagonally.
Point cleaning is not
working.
"Filter inspection indicator"
is on even after the dustbin
has been emptied.
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
- When "Lo" is displayed, carry POWERbot to the docking station to
charge it.
fReplace the batteries (AAA type) if the remote control is not working.
fWhen "Lo" is displayed on the display panel, carry POWERbot to the
docking station to charge it.
fWhen POWERbot is immobilized by an obstacle such as a cord,
threshold etc, pick it up and move it away from the obstacle.
- If any fabric or string is caught in a drive wheel, turn off the emergency
switch and remove the fabric or string before using it again.
fIf the "Filter inspection indicator" is on, turn off the emergency switch and
clean the dustbin.
fWhen there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
fIf the intake (on bottom of POWERbot) is blocked by foreign matter, turn
off the emergency switch and remove foreign matter from the intake.
fWhen noise suddenly increase, turn off the emergency switch and empty
the dustbin.
fCheck if there's a power failure or whether the power plug is unplugged.
fRemove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
fWhen there's foreign matter on the charge pins, charging can be
affected. Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of wooden floors
or tiles.
fThe POWERbot may clean in a diagonal direction if it is moving to
another area using the shortest route. It may also move at a diagonal
if it made contact with an obstacles at that angle, if it was charged at
the docking station at an angle, or if the grain of the wooden/tile floor
skewed is in that direction.
fIf you point the red light directly at POWERbot, it may not move in
desired direction.
- Point the red light on the floor within 4 ft (1 m) of POWERbot.
✻ ✻ Do not use point cleaning in direct sunlight, under bright light, or on dark
floors.
fTurn off the emergency switch and then turn it back on.
fEmpty the dustbin again and re-clean the filter thoroughly.
ENGLISH-32
checklist